| 15001 |
Selected source zone <name> does not belong to the solution source map file. |
| 15002 |
Cyclic zone <name> has an invalid number of segments. |
| 15003 |
Cyclic zone <name> has an invalid rotation axis. |
| 15004 |
Symmetry zone <name> used for mapping contains non-axisymmetric meshes. |
| 15005 |
Symmetry zone <name> used for mapping contains inconsistent axisymmetric meshes with variable axis coordinates and/or segment numbers. |
| 15006 |
Symmetry zone <name> used for mapping contains axisymmetric meshes with unsupported axis values. The only supported axis are OX, OY, OZ. |
| 15007 |
Symmetry zone <name> used for mapping contains elements that do not all belong to a single plane containing the axis. |
| 15008 |
Symmetry zone <name>cannot use the option <From Element> for <Axis> as the containing FEM does not have an axisymmetric extension. |
| 15009 |
Could not get coordinates of the node <ID>. |
| 15010 |
Node <ID> could not be mapped. |
| 15011 |
Could not open results file <name>. |
| 15012 |
Could not open input file <fldmap.dat>. |
| 15013 |
Not all source alignment points are defined. |
| 15014 |
Not all target alignment points are defined. |
| 15015 |
Points used for alignment are located along a line - (almost) collinear. |
| 15016 |
Layer specification zone(s) exist, but the source bun file does not contain elemental temperatures. This cannnot be handled. |
| 15017 |
The <Append Results> function is enabled, but the current output times are different from those in the file to append to. |
| 15018 |
Target zone <name> intersects target zone <name> .One example of a common node is <ID>. |
| 15019 |
There are transient gradient zones defined in the solution, but the source bun file does not contain nodal results. This is not supported. |
| 15020 |
The <Append Results> function is enabled, but the current target model is different from the one in the file to append to. |
| 15021 |
Mapper input data are not valid. |
| 15022 |
Invalid Source Model: it does not seem to have a mesh. Check the <Source Model Results File> and its corresponding input xml file. |
| 15023 |
The mapping geometry source file tmggeom.dat does not exist. Make sure that the following mapping source files: 1) tmggeom.dat, 2) INPF, 3) TEMPF or WATERDENSF are present in the mapping source directory: <name>. |
| 15024 |
The mapping data source file INPF does not exist. Make sure that the following mapping source files: 1) tmggeom.dat, 2) INPF, 3) TEMPF or WATERDENSF are present in the mapping source directory: <name>. |
| 15025 |
The mapping temperature (or water density) source file TEMPF (or WATERDENSF) does not exist. Make sure that the following mapping source files 1) tmggeom.dat, 2) INPF, 3) TEMPF or WATERDENSF are present in the mapping source directory: <name>. |
| 15026 |
Symmetry zone <name> Some axi target nodes are not in the symmetry plane. |
| 15027 |
More than one Source Model Mapping simulation object detected in solution. Only one Source Model Mapping simulation object per solution is supported. Please review solution accordingly. |
| 15028 |
Element <ID> found in mapping target set selection has unsupported type <integer>. |
